D_BREAK, set using set_breakpoint/4. Clause and PC identify the breakpoint. FR and BFR provide the environment frame and current choicepoint. Expression identifies the action that is interrupted, and is one of the following:
- The instruction will call Goal. This is generated for nearly
all instructions. Note that Goal is semantically equivalent
to the compiled body term, but might differ syntactically. This is
notably the case when arithmetic expressions are compiled in optimized
mode (see optimise).
In particular, the arguments of arithmetic expressions have already been
evaluated. Thus, A is 3*B, where B
equals 3 results in a term
call(A is 9)if the clause was compiled with optimization enabled.
- The instruction will call the cut. Because the semantics of metacalling
the cut differs from executing the cut in its original context we do not
wrap the cut in
- The breakpoint is on the neck instruction, i.e., after performing the head unifications.
- The breakpoint is on the exit instruction, i.e., at the end of the clause. Note that the exit instruction may not be reached due to last-call optimisation.
- The breakpoint is on the completion of an in-lined unification while the system is not in debug mode. If the system is in debug mode, inlined unification is returned as call(Var=Term).224This hack will disappear if we find a good solution for applying D_BREAK to inlined unification. Only option might be to place the break on both the unification start and end instructions.
If prolog:break_hook/6 succeeds, it must unify Action with a value that describes how execution must continue. Possible values for Action are:
- Just continue as if no breakpoint was present.
- Continue in debug mode. See debug/0.
- Continue in trace mode. See trace/0.
- Execute Goal instead of the goal that would be executed. Goal is executed as call/1, preserving (non-)determinism and exceptions.
If this hook throws an exception, the exception is propagated
normally. If this hook is not defined or fails, the default action is
executed. This implies that, if the thread is in debug mode, the tracer
will be enabled (
trace) and otherwise the breakpoint is
This hook allows for injecting various debugging scenarios into the executable without recompiling. The hook can access variables of the calling context using the frame inspection predicates. Here are some examples.
- Create conditional breakpoints by imposing conditions
before deciding the return
- Watch variables at a specific point in the execution. Note that binding of these variables can be monitored using attributed variables, see section 8.1.
- Dynamically add assertions on variables using assertion/1.
- Wrap the Goal into a meta-call that traces progress of the Goal.